The Nichols flywheel performs very well, however there was a bit of a challenge in getting the VeeTwo basket/hub and Barnett Clutch to perform. The malfunction, however, was at the slave cylinder side, and was the result of the shorter (225mm) pushrod of my 1999, compared with the longer (235mm) pushrod of the later bikes. Also, the STM pushrod pin (cup that fits into the pressure plate bearing) had the small bearing inside it seize, and had begun to drill into my original pushrod, and similarly the clutch pressure plate bearing had all but given up as well. The combination of tight spot in the bearing, short pushrod, and seized pushrod pin bearing had the bike unable to shift gears very well (The clutch wouldn't disengage without repeated pumping of the lever). Stuart Rust was able to identify the problem, and we replaced all failing components, and bolted up a new Ducati Performance slave cylinder as well. (Turns out the malfunction was from no fault of my own!)
Here's a pic from about a week ago, and but they don't include the new slave cylinder, or new tires yet. New pics tomorrowish with the bike geared up and ready to go.
